Welcome

thedude · thedude

Good day.. till where exactly must one fill the collant in the heat exchanger (Beta 35) ...the manual says till 25mm below the filler neck but is that from the top of the neck (ie where the pressure cap touches the neck) or does this refer to 1inch below from the base of the neck therfore extending 1inch do...

Rod · Rod

I have a Beta 35 with the TMC60A transmission installed on my sailboat. For the past year, I have noticed a small amount of ATF drips beneath the transmission. The fluid level drops from the full mark to the add mark over about 75 hours of operation. The leak appears to be coming from the aft seal area w...

Toucan · Toucan

Having a problem. (I have two 13.5 hp) While motoring at a steady rpm say 2500, everything is fine until I hit a bad wake or am in rough seas.. the rpm on the port engine will start going from 2500 to 3000 and back to 2500 bouncing back and forth. Has anyone seen this or have any idea what to check or do. If I li...

Sailorphil · Sailorphil

I repowered my 34' sloop 9 years ago with a Beta 25. I'm very happy with the results, the engine/trans have performed well in all respects. However this Fall, after winterizing, I realized that the Johnson water pump (207-61500/01) was leaking. I removed the pump from the engine and disassembled sa...

jmlinne · jmlinne

I just bought a Westsail 32with a Beta 38 4C1478 which ran well for the sea trial and subsequently. It has only 30 hrs use. However the engine/transmission control mount fell apart at the first attempted use. I just finished fabricating a new mount and it works well. Meanwhile I also had to replace...

Topic		Started By	Replies	Views	Last Post
	Coolant heat exchanger (Preview) Good day.. till where exactly must one fill the collant in the heat exchanger (Beta 35) ...the manual says till 25mm below the filler neck but is that from the top of the neck (ie where the pressure cap touches the neck) or does this refer to 1inch below from the base of the neck therfore extending 1inch do...	thedude	8	1925	Sep 9, 2019 by Farron
	TMC60A Leak Repair (Preview) I have a Beta 35 with the TMC60A transmission installed on my sailboat. For the past year, I have noticed a small amount of ATF drips beneath the transmission. The fluid level drops from the full mark to the add mark over about 75 hours of operation. The leak appears to be coming from the aft seal area w...	Rod	2	1232	Aug 26, 2019 by Fahrenheit
	Rpm surging (Preview) Having a problem. (I have two 13.5 hp) While motoring at a steady rpm say 2500, everything is fine until I hit a bad wake or am in rough seas.. the rpm on the port engine will start going from 2500 to 3000 and back to 2500 bouncing back and forth. Has anyone seen this or have any idea what to check or do. If I li...	Toucan	2	1529	Dec 6, 2018 by Toucan
	Beta 25 Raw water pump (Preview) I repowered my 34' sloop 9 years ago with a Beta 25. I'm very happy with the results, the engine/trans have performed well in all respects. However this Fall, after winterizing, I realized that the Johnson water pump (207-61500/01) was leaking. I removed the pump from the engine and disassembled sa...	Sailorphil	4	2143	Dec 16, 2018 by Sailorphil
	Idle rpm (Preview) I just bought a Westsail 32with a Beta 38 4C1478 which ran well for the sea trial and subsequently. It has only 30 hrs use. However the engine/transmission control mount fell apart at the first attempted use. I just finished fabricating a new mount and it works well. Meanwhile I also had to replace...	jmlinne	3	2151	May 14, 2018 by Stanley
«First < 1 2 3 4 … 24 > Last» \| Page of 24 sorted by