Welcome

Warren · Warren

Hi, i have a friend with a beta 25 (i think about 5 years old). he has fuel pick up problems because of the shape of his fuel tank on his sailboat when sailing on one tack. He wants to add a second pick up at an lower point by cutting into his tank!!! I suggested a simpler approach is he add a small alum header t...

thedude · thedude

Good day.. till where exactly must one fill the collant in the heat exchanger (Beta 35) ...the manual says till 25mm below the filler neck but is that from the top of the neck (ie where the pressure cap touches the neck) or does this refer to 1inch below from the base of the neck therfore extending 1inch do...

Rod · Rod

I have a Beta 35 with the TMC60A transmission installed on my sailboat. For the past year, I have noticed a small amount of ATF drips beneath the transmission. The fluid level drops from the full mark to the add mark over about 75 hours of operation. The leak appears to be coming from the aft seal area w...

Toucan · Toucan

Having a problem. (I have two 13.5 hp) While motoring at a steady rpm say 2500, everything is fine until I hit a bad wake or am in rough seas.. the rpm on the port engine will start going from 2500 to 3000 and back to 2500 bouncing back and forth. Has anyone seen this or have any idea what to check or do. If I li...

Sailorphil · Sailorphil

I repowered my 34' sloop 9 years ago with a Beta 25. I'm very happy with the results, the engine/trans have performed well in all respects. However this Fall, after winterizing, I realized that the Johnson water pump (207-61500/01) was leaking. I removed the pump from the engine and disassembled sa...

Topic		Started By	Replies	Views	Last Post
	fuel header tank lift pump header tank fuel pick up (Preview) Hi, i have a friend with a beta 25 (i think about 5 years old). he has fuel pick up problems because of the shape of his fuel tank on his sailboat when sailing on one tack. He wants to add a second pick up at an lower point by cutting into his tank!!! I suggested a simpler approach is he add a small alum header t...	Warren	2	191	October 31st by Warren
	Coolant heat exchanger (Preview) Good day.. till where exactly must one fill the collant in the heat exchanger (Beta 35) ...the manual says till 25mm below the filler neck but is that from the top of the neck (ie where the pressure cap touches the neck) or does this refer to 1inch below from the base of the neck therfore extending 1inch do...	thedude	8	307	September 9th by Farron
	TMC60A Leak Repair (Preview) I have a Beta 35 with the TMC60A transmission installed on my sailboat. For the past year, I have noticed a small amount of ATF drips beneath the transmission. The fluid level drops from the full mark to the add mark over about 75 hours of operation. The leak appears to be coming from the aft seal area w...	Rod	2	219	Aug 26, 2019 by Fahrenheit
	Rpm surging (Preview) Having a problem. (I have two 13.5 hp) While motoring at a steady rpm say 2500, everything is fine until I hit a bad wake or am in rough seas.. the rpm on the port engine will start going from 2500 to 3000 and back to 2500 bouncing back and forth. Has anyone seen this or have any idea what to check or do. If I li...	Toucan	2	447	Dec 6, 2018 by Toucan
	Beta 25 Raw water pump (Preview) I repowered my 34' sloop 9 years ago with a Beta 25. I'm very happy with the results, the engine/trans have performed well in all respects. However this Fall, after winterizing, I realized that the Johnson water pump (207-61500/01) was leaking. I removed the pump from the engine and disassembled sa...	Sailorphil	4	631	Dec 16, 2018 by Sailorphil
1 2 3 … 23 > Last» \| Page of 23 sorted by