|
Raw water supply sizing
(Preview)
I'm replacing a Yanmar 1GM10 with a Beta Marine 14. Existing raw water hoses, from the sea**** to the filter, and the filter to the water pump, are 1/2 inch (12mm). Beta Marine specifies 3/4" (19 mm) raw water hoses for their engine sizes 10 to 45 hp. Given that the largest of the engines in this range is mo...
|
StuartWeibel
|
2
|
1950
|
|
|
|
|
Air in fuel, Beta 20
(Preview)
I recently had an air problem in the fuel on Beta 20. I changed the primary fuel filter 3 weeks ago and engine ran fine afterwards until a few days ago when it cut out after 2 full days (12 hours) of running. On "cut out day" ran as normal for about 45 minutes, I turned it off and sailed for 20 minutes, and then r...
|
Sailorron
|
1
|
1442
|
|
|
|
|
exhaust system design for beta 50 hp
(Preview)
Hi Stanley, would greatly appreciate you advice. first my old system see attached (pic 02,52,33)-had 60 hp perkins #4203 repowering with Beta 50hp. next plan A system (see attached drawing) with two waterlocks drawing. even with the two waterlocks I don't think they can handle the volume of water i...
|
djsaxton
|
8
|
1585
|
|
|
|
|
Beta 50 Bleeding Problems
(Preview)
Replaced primary and secondary fuel filters today. After bleeding engine it ran for about 5 minutes and then stopped. Bleeding was repeated with similar results. Plan to check for possible leak at the primary filter, secondary filter, and bleed screw. Any other suggestions?
|
Mississippi Sailor
|
1
|
1114
|
|
|
|
|
New comer with a BF2803 62 bhp
(Preview)
Hi all, I am a new comer on the forum and new as well on engine boat (my short background is in sailing). I got few month ago a "vedette hollandaise" (dutch boat) which is quite nice. Unfortunately I can't find much littérature about it. Does anyone know this engine ? Thanks in advance for help. Frédéric (...
|
Lorenzini
|
2
|
909
|
|
|
